Your Cart

TSOP1838 Infrared Sensor

TSOP1838 Infrared Sensor
High Quality Product
Proved by satisfied customers
  • Stock: In Stock
  • Model: TSOP1838
  • Weight: 10.00kg
  • Dimensions: 1.00cm x 0.90cm x 0.60cm
191 samples sold
$ 3.53
Ex Tax: $ 3.53






The TSOP 1838 is a member of IR remote control receiver series. This IR sensor module consists of a PIN diode and a pre amplifier which are embedded into a single package. The output of TSOP is active low and it gives +5V in off state. When IR waves, from a source, with a centre frequency of 38 kHz incident on it, its output goes low. 
Lights coming from sunlight, fluorescent lamps etc. may cause disturbance to it and result in undesirable output even when the source is not transmitting IR signals. A bandpass filter, an integrator stage and an automatic gain control are used to suppress such disturbances.
  • Photo detector and preamplifier in one package
  • Internal filter for PCM frequency
  • TTL and CMOS compatibility
  • Output active low
  • Improved shielding against electrical field disturbance
  • Suitable burst length ≥6 cycles/burst 
  • Small size package
  • Enhanced immunity against all kinds of disturbance light
  • No occurrence of disturbance pulses at the output
  • Short settling time after power on (<200s)

Operating Supply Voltage (Typ)                                             3.3/5V

Operating Supply Voltage (Min)                                             3V

Operating Supply Voltage (Max)                                             6V

Mounting                                                                               Through Hole

Whatsapp Chat - Twins Chip
Technical Support